Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dingbatca on August 05, 2008, 12:05:31 PM
-
Does any one know what a "G&L Beijer MAC/ MTA E300 Operator Interface Panel" is, or if I could adapt it to run with Mach?
-
Sounds like its just an operator panel that interfaces with one of Giddings and Lewis motion controllers. Do you have the rest of the system or is it just the Operator Interface you have?
Hood
-
This is all I have.
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=110276720592
-
It is just an control panel and its specific to a certain control I think.
Dont think that will be much use for you, potentially you could interface the keypad and buttons to Mach but it would take a lot of working out and not worth it in my opinion. :(
Hood
-
Thats what I was thinking. That is why I put it on e-bay.