Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Graham Waterworth on December 11, 2005, 06:43:00 AM
-
Hi All,
I am a bit new to this CNC retrofitting lark, although I have been using and programming the full size stuff for 20 years.
I am in the process of converting my lathe (Warco 250) to CNC and want to fit MPG's, my question is what type to buy and where to get them.
Thanks
Graham
-
Graham,
I sell the Micronor MPG's, the same type that Fanuc and many of the OEM's use.
www.rogersmachine.net
Ron