Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bpmufx on May 27, 2006, 01:46:14 PM
-
Hi everyone,
Has anyone seen the Mach2 post processor for Bobcad V19 crash the app? I have other posts for other machines
and have not had a problem. I've never actually crashed Bobcad until now, but I loaded the Mach2 post
(from Bobcad site) and can't get the simplest of toolpaths to post out without crashing.
Does anyone have some thoughts on the matter?
Thank you very much
Evan