Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ralaco on July 02, 2008, 12:35:30 PM
-
I’m upgrading mach2 to mach3, but when I try to open “motor tuning” from config the window doesn’t pop up.
Is there a new way to open Motor Tuning in mach3?
I can open all the other files from config, my problem is only with Motor Tuning.
Raul
-
The window should pop up like the pic below. If it doesnt then try downloading and reinstalling Mach again.
Hood
-
Hi, Raul
I've had this happen from time to time also, As Hood stated, The only way to resolve this is to re-install Mach.
Chip