Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: giordano on June 27, 2008, 07:47:00 AM

Title: Idea compensation planarità
Post by: giordano on June 27, 2008, 07:47:00 AM

Hi to all. be a good idea, set zero the utensil in default points, to make to calculate to Mach3 a compensation of the planarità of the surface of support of the piece to work? excuse my English. Hi to everybody. Giordano

Title: Re: Idea compensation planarità
Post by: Hood on June 27, 2008, 10:53:00 AM

Sorry Giordano, dont understand what you are asking :(

Hood

Title: Re: Idea compensation planarità
Post by: giordano on June 27, 2008, 02:51:31 PM

Sorry .... sometimes the work plan is not perfectly linear. From x0 to xmax and y0 to ymax could be a small difference in height. It would be a good idea to make Mach3 setting these values be able to perform processing offsetting these differences. Hello Giordano.

Title: Re: Idea compensation planarità
Post by: Overloaded on June 27, 2008, 07:45:23 PM

Hello Giordano,
Do you mean to have Mach compensate for a twisted or warped table and have the Z axis Zero always the same distance from the table ?
  If that is what you mean, I'm not sure that it can. You would probably need to true up your machine.
RC