Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Saumur on June 26, 2008, 12:05:21 PM
-
Hi guys,
when i load a g-code the screen with the toolpath shows up normally.
the problem is that if i zoom on it, after i edit the program the screen will unzoom and go back to normal position.
Is there a way to keep the toolpath zoomed as you prefere everytime?
thanks
-
No dont think there is, the reason being is when you edit the programme you are in effect reloading it and Mach regenerates the toolpath.
Hood
-
thanks for your answer, can some1 confirm it?
thanks
-
yes
(;-) TP