Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: nilesh on June 25, 2008, 01:43:12 AM
-
hi all
i having galil DMC-2123 controller. i am running galil controller through MACH3.
1:can i use the DMC-2123 controller input / output (other than limit and home) using MACH3
2:how can i interface my software with MACH3
i want to start MACH3 motion through my software.
my configuration is : Controller: DMC-2123
drive (daughter card) :SDM-20640
-
? do you mean you have your own Software interface and you want to call mach3 under it, if so, look at the downloads for the Remote Mach SDK.
-
ahhh,
got a hold of Hillbilly, you take the Inputs and Outputs on the galill card, and set that I or O to its equivelent pin number.
The Galil loads as Port 1 in Ports and Pins,
So Input Pin on the Galil would equat to Port1, Pin1 on inputs, So, INPUT1 = 1, 1
INPUT2 = 1,2 etc.
Scott