Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: davestea on May 22, 2006, 10:20:37 PM
-
using M3 lathe Sherline R1.84
loaded by dealer on supplied system from TableTop.
acts the same as my demo copy -
clicking on file - import dxf does nothing at all -
what am I doing wrong? tried all 3 main screens
ds
-
The DXF importer is not working because the old one was taken out... we will be building up a new one but it is going to be many months before we have it done.
Sorry about that
Brian
-
ok - so any suggestions on how I can convert a dxf to g-code so I can get it into M3?
OH! and not have to spend another fortune ---
-
try lazycam, it comes bundeled with mach 3, look for it on the mach3 folder, there is a video about lazycam on the tutorials section on this website
hope that would get you started
Fernando
-
If it is a mill you should be Good to go with LCAM but if ti is a lathe it is going to be a bit...