Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Peter Zicha on June 03, 2008, 04:21:21 PM

Title: changing stepper directions
Post by: Peter Zicha on June 03, 2008, 04:21:21 PM

Got my control box hooked up but my  Z , Y , A  axis are going the wrong direction.....X is correct , can this be reversed in the software

thank you

Title: Re: changing stepper directions
Post by: Hood on June 03, 2008, 04:25:06 PM

Few ways to do it, changing the active state for the Dir pin will do it but  some drives have issues with that so you can also reverse the direction by going to the Config menu then Homing and Limits.
Hood

Title: Re: changing stepper directions
Post by: Peter Zicha on June 04, 2008, 03:02:06 AM

Thanks hood , got her all strait now