Machsupport Forum
General CNC Chat => Show"N"Tell ( What you have made with your CNC machine.) => Topic started by: fdos on May 31, 2008, 06:44:07 PM
-
Not bad, except I machined through in a couple of places!
VMC was doing nothing much last night so I let it run through the night. My slow! 6000rpm spindle meant the feedrates had to be kept down with a 1mm dia ballnose.
Subject is Devo's Bob Mothersbaugh wearing my other handiwork on his head!
Wayne....
-
Brilliant work.
-
Good Job Wayne. I haven't made any yet because the only mill I have running now is just too slow. My friend was one of the originals working with ArtCam to help perfect the process. Neat isn't it?
Brett
-
Thanks. well the picture above is of my 1st attempt which screwed up, I machined through in a few places.
Did it again and was perfect. I gave the picture to Bob who is the person in the pic last week when I met him in Paris.
I'd try a few more later, but I'll probably build a high speed router to do them on rather than tie up the VMC.
Wayne...
-
Did you use Vectric PhotoCarve for this? Also, what material?