Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bobo on May 19, 2006, 10:14:10 AM
-
When I push the right cursor key the y axis move in the positive direction. I must have messed up something in my profile. My machine is mirroring everything.
Thx for any help.
-
If you go to the config menu then down to system hotkeys you can then click on the x++ and then press the key you want to use, same for the rest of the axis.
Hood
-
Check to be sure that you don't have your axis set to run in the reverse direction of what it should be...
Thank you
Brian
-
That was easy!!!
Thanks Guys.