Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: P Sheres on May 29, 2008, 08:59:25 AM

Title: Bi-directional Jogging
Post by: P Sheres on May 29, 2008, 08:59:25 AM

My x and Z axis only turns clockwise and my Y axis does not jog at all.  Any suggestions?

Title: Re: Bi-directional Jogging
Post by: Hood on May 29, 2008, 10:51:16 AM

Sounds like you have your pins asigned incorrectly, or could be your parallel port cable is bad. Please attach your xml, you will need to rename it to post to the forum, suggest you rename it to P_Sheres.xml

Hood

Title: Re: Bi-directional Jogging
Post by: Peter Zicha on June 03, 2008, 04:17:29 PM

I ran into that also , mine was the pin asignments