Machsupport Forum
Third party software and hardware support forums. => NC Pod => Topic started by: apollonono on May 28, 2008, 12:45:50 PM
-
hi, everyone. Him (ncPOD-OEMTEC) you know thing who? If he has lived, appearing in this place, story should be done, with you don't think? ???
-
I would have to agree with this logic.
-
???????????????????????????????????????????????
Zarzul.....Help.......Please translate......????????????
-
I think he was asking that - shouldn't a story or information about the person who invented the NCpod device be done here on the NCpod forum area?
Bit of a guess though.
-
Better guess than mine......thanks.
RC
-
Ya Im thinking that as well?? Look on the ncPod web, last update 2007. I have a pod here, and am about to experiment with it and Mach3. Presently running TurboCNC on a ols 200Mhz Pentium. Want to use my Laptop for milling, but no parralel port