Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bankshot on May 26, 2008, 08:34:53 PM
-
in my driver test, the freq. is 25997, is this a problem being too high, how do i change it if it is?
-
I cant see that being a problem - mine is around 24,000 - on this computer. I haven't tried the workshop computer, but the driver test says it's OK.
You've been on with this for quite some time, what's the problem.
-
Hi, Larry
What Stepper/driver board are you using, Try the Sherline 1/2 step mode, Your board may need more time to see Mach's Pulses.
Try that first, Thar's a doc to optimize Windows if needed. http://www.machsupport.com/downloads/XP_Optimization.txt
Chip