Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bill C on May 07, 2008, 11:18:04 AM
-
Where can I locate a post processor for Enroute 3?
-
I guess this should be the post from EnRoute 3 to Mach 3
-
What is the 'file type' output from EnRoute ?
-
I'm not sure what code or file type En Route generates. It's probably a standard G Code. I don't have the post to send my files to Mach 3. This is an old version that doesn't have all the post processors listed.
Thanks and the photo of Sam make me laugh. She must be family.