Machsupport Forum
General CNC Chat => Show"N"Tell ( Your Machines) => Topic started by: wyo123 on May 05, 2008, 12:36:23 PM
-
Hello,
I just purchased a basket case VMC.
It needs alot of work and I am looking at 10K just to get the controls going agian.
This would be the 1997 seicos control, and who knows when it will be smoked again.
Would it be a good idea to try and retrofit something like this with mach 3?
The only thing I can see causing a problem would be controling the spindle drive, it looks like the OEM control uses a digital bus for all the drives.
Here is a link to it on ebay:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=280214611136&ssPageName=STRK:MEDW:IT&ih=018
Let me know thanks.
-
Hmmmmmmmm, lots of questions to ask. You need to find out what type control signal the drives will take. Are they not analog? I doubt they are step and direction.
Brett
-
Jus figured out that it uses yaskawa drives, that is a good thing because I think it might use -+ 0-10 V
I should be able to make Mach3 control that.
Let me know what you guys think
Thanks