Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: mir3 on April 26, 2008, 06:47:03 AM

Title: Resolver and MACH3
Post by: mir3 on April 26, 2008, 06:47:03 AM
Most of old servo machines have resolvers for axis positioning >:(.
New RES3 module is intendend to be interface between MACH3 and axis amplifier ???.
It can accept pulse input from parallel port for direction and speed, provide supply for resolver and output analog signal 10VDC (positive and negativeĀ  ;)) for axis amplifier.
Contain and PID regulator :o.
All parameters could be adjusted via RS232 input or RS485 busĀ  :).
Tested with Fadal VMC.
If there is any interest contact me on
info@dizalice.net