Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Graham Waterworth on May 15, 2006, 06:12:02 PM
-
Hi All,
I have just got myself a CNC mini lathe, it has no spindle control so I was wondering if any body can tell me of an interface card that would allow me and Mach3 to do this with the existing built in variable speed controller, its part number is FC150BJ/230V
Any help would be great.
Thanks
Graham.
-
Check this out ... I think this is low cost stuff... http://www.kbelectronics.com/