Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Biotech1 on April 13, 2008, 05:07:38 PM
-
Puzzled ??? i made 2 1 inch squares and 2 1 inch circles I pocketed 1 square and one circle it came out at .9998 and when i do the profile outside its bigger than 1 inch and I'm using a .125endmill with vcarve pro.... any suggestions as to why its perfect one one and real crappy on the other...
-
Hi, Biotech1
So what's the, "real crappy on the other..." values.
Not to much info in your post to work with, Is it Backlash, Flex.
Thanks, Chip
-
Mill bit is too small, it's walking around one way on the inside cut and the other way on the outside cut. Use as big a mill as possible when you can.