Machsupport Forum
Third party software and hardware support forums. => NC Pod => Topic started by: Greolt on April 13, 2008, 05:14:32 AM
-
Anybody running an NCpod direct connect to a Xylotex driver board?
Wondering if there are any issues I should be aware of.
Presume I just connect step, direction and ground for each axis.
All limits, estop and outputs direct from NCpod to relevant purpose.
Greg
-
I did as I said above and it works fine.
Greg
-
Hi Greg,
All you need now is to get your ncPod to runyour spindle via a DC-05 DigiSpeed-MC :-)
http://homanndesigns.com/store/index.php?main_page=product_info&cPath=1&products_id=38
Cheers,
Peter.