Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: curtisturner on April 12, 2008, 04:30:33 PM
-
I have several hubbard relay boards and I can not seem to get them working at all.
I set it up for pin 16 and pin 17 and then set up the outputs 1 and 2 for pin 16 and pin 17.
Set the spindle relay on for output 1 and the flood for on for output 2
I have tried all 3 boards so there seem to not be a board problem.
HELP?
Thanks in advanced
Curtis
-
Did you check to see if the there is output on the pin when active with a volt meter?