Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: yahuie on April 11, 2008, 11:51:49 PM

Title: wierd behavior
Post by: yahuie on April 11, 2008, 11:51:49 PM
Hi,

I was running a program when the machine started a x axis move before reaching the correct y axis point.  I checked the program which is correct.  There were also no missed steps.  I don't know what caused this.  Is there anything that could make mach not complete a line before moving to the next?  I have turned off the screen saver.  Should I also turn off the 'auto off' function for the monitor? 

Any ideas would be appreciated.

Thanks,

Bill
Title: Re: wierd behavior
Post by: Hood on April 12, 2008, 03:51:11 AM
Please attach your xml, I had this happen a while back and when I compared a saved xml and the present one there was a difference. I cant remember what it was but maybe if I see your xml it will jog my memory.
Hood
Title: Re: wierd behavior
Post by: Freeze_Tec on April 13, 2008, 05:20:46 AM
Hi,

What you describe here. is similar to what Spinnetti  has posted on another topic on this forum (Code wanders off)
In my case setting the "look ahead" to 1 seemed to help

Jan