Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: lowslo on April 09, 2008, 10:35:00 PM
-
Hey all. I'm in the process of finishing my first router and I have been playing around with Mach 3 and Lazy Cam. So far after trying many options that are available I think that Mach 3 is by far the easiest to use. At least for a newbie like me.
I tried to search for the answer to my question but couldn't find it. I can only post 49 lines of code in Mach 3. Is that normal before licensing or am I doing something wrong? I was under the impression that there was a 500 line limit. Kind of hard to evaluate it with only 49 lines available :)
I tried several of my drawings but all only result in 49 lines of code (full drawing in Lazy Cam though).
Thanks so much for your help.
Ryan
-
Hi Ryan,
Without either a Mach or a LazyCam license, LazyCam will only generate 50 lines of Gcode... With a LazyCam license (but without a Mach license), you would be restricted to the normal 500 lines... ;)
Thanks,
scott
-
Thanks scottn. Just wanted to make sure there wasn't something else wrong. License it is then. 8)
Ryan