Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ayhan on April 04, 2008, 03:14:35 AM
-
Hello everyone, :)
After M3 or M5 command axes wait nearly 2 seconds, for spindle turn (or off).
How can I change waiting time as 0 (zero) ?
Ayhan
-
See Config/Ports and Pins/Spindle Setup.
You can configure the delay to what you want for M3,M4 and M5
-
I did
Excuse me, for it , I did not notice "spindle setup" before.
Thank you very much.
Ayhan