Machsupport Forum

Third party software and hardware support forums. => Galil => Topic started by: manoj2s on April 04, 2008, 03:03:28 AM

Title: Mach3 + Galil DMC2133
Post by: manoj2s on April 04, 2008, 03:03:28 AM

Hi all,

I am having Galil DMC-2123 controller with onboard AMP 20540 drive & pittman motors. I want to use MACH3 for 2 axis truning job application where i am going to retrofit a OLD manual lath.

I have downloaded MACH3 & pluging for Galil controller, they are communicating very well but my problem is i want to configure AXIS of Galil controller with Mach3 for turn application.

For example i want to used X & Z axis for turn application how can i do it.
Please advice.

Thanks
Manoj

Title: Re: Mach3 + Galil DMC2133
Post by: smurph on April 09, 2009, 05:12:48 PM

The new Galil plugin (V4.0) allows axis mapping.  It will do what you are wanting to do.  You can download this new version on the plugin download page.  Read the documentation, as there are a few things that are different from the V3.0 plugin.

Steve