Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: BosniaCNC on April 01, 2008, 05:29:20 PM
-
::)
????? Where is problem?????????????
S.Markovic
-
What makes this happen? does it always happen or just with that code? Is it just when you load the code or is it after the code has been running a while?
Any other details you can give may help.
Hood
-
Now, Mach3 is OK !
I will tested again from Mach1 to Mach3.
Thank on your post,
S.Markovic