Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ojibberish on March 25, 2008, 02:48:54 PM
-
Hello,
I was wondering if anyone might be able to help me out. If I stop a Mach 3 program when it's running (by any means E-stop or just choosing "stop") any subsequent jogs result in an uncontrollable rapid of all three x, y and z axes all the way in the positive direction. I have to estop, and restart Mach 3. I've successfully run a few parts, but this jogging issue is enough to drive me crazy!
I'm using a G100 over ethernet attached to 3 G203V stepper drives.
Thanks,
Christopher