Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Tef9 on March 19, 2008, 11:02:48 AM
-
Hi There I am new to Mach 3.
I would like to input a diameter of a part into mach 3 turn and then input a diameter that I want the machine to turn the part down to. I have looked at the wizards and cannot see this, I current set an x start and end with a z start and z end.
Help,
Thanks,
Andy
-
I have several Macros in my machine that will do just that. I have put extra DRO's on the front of Turn in which I can enter various parameters - Start dia, End dia, Length of Cut etc. I work in steel so only take off 20 thou at a time, but you could also include depth of cut.
I don't know how adept you are at changing the screens - and I can't work out how to get a screen shot onto the forum - but here is the Vis Basic.
M201 does what you want, M202 puts a rounded end on it.
The screen is on 1024.lset - page 4
-
Sorry - I missed something
-
Thanks I will give this a go tonight.
Andy