Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wss on March 10, 2008, 03:32:47 PM
-
I have been using Mach2 for a few years now with a very personal item - I have had very good results.
I have a need to resize a current part but do not want to go through the CAM process again to resize it.
Any suggestions?
Thanks
-
Excuse me - CAD process.
-
You can scale each axis in Mach, so if you want to make the part double the sizeput 2 in each scale DRO, if you want to reduce it by half then put 0.5 in them.
Hood
-
Great -- thanks.