Machsupport Forum

Third party software and hardware support forums. => NC Pod => Topic started by: usfwalden on March 07, 2008, 12:06:12 AM

Title: ncpod plugin is final..is ncpod done?
Post by: usfwalden on March 07, 2008, 12:06:12 AM

I have a large mill with lots of switches and relays and I'm putting a vfd on the spindle motor and I'd really like to run it with mach on a laptop with usb.  I see the ncpod plugin is listed as a final full version on the artsoft website but I can't find the ncpod anywhere to purchase it.

I also saw in the development thread that there was a timing issue with the beta units.  Was that fixed and there is now a fully functional ncpod available for purchase somewhere?