Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Anthony on February 25, 2008, 03:28:20 AM
-
Hi,
Can you tell me how to put timings in a GCode program ?
Thank you
-
If you are meaning a dwell then its G4P*
Where the * is seconds, unless that is you have the option in General config page checked for milli seconds then it will be milliseconds.
Hood
-
Hi! Hood,I tried it and thank you so much.
regards
Anthony
-
Hi! Hood, it is OK, thanks.
regards
Anthony