Machsupport Forum
G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: cosmynnec on May 03, 2006, 12:56:56 PM
-
I have this part with 2 layers, the 1 layer the outside of the piece the 2nd layer the circle in the middle of the piece.
I have tried everyway I can to get LazyCam to cut the circle on the inside instead of the outside. But it continues to cut outside . If I enable a straight lead-in of 3mm the leadin extends beyond the edge of the circle
Cosmy
-
Hi, Cosmy
Have you tryed the 45 or cir. leadin or is this a cutter dia. problem your having.
Try the Atachment below.
Hope this help's, Chip
-
Yes my problem is the cutter dia. if i don't check that option "Use G41/G42 .... " when i want to generate the g-code it's working but without compensation. I think that the program reverses the G41 and G42 codes.
-
I have been fixing bugs and that one is on the list...
Thank you