Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: Garyv on February 20, 2008, 03:13:14 PM
-
Is_anyone_familiar_with_a_Parvex_servo_motor?Good_or_bad?
I_just_got_one_on_Ebay_for_$1.25_plus_$12_bucks_shipping_I_already_run_servos_on_my_mill
_now_and_I_am_getting_parts_together_for_a_router_table_will_be_using_my_Gecko_320s_
to_run_it_but_my_main_question_is_torque_rating_most_of_the_time_you_see_it_listed_in_lb's_of_torque_
the_spec_sheet_on_this_one_shows_.78Nm_rating?
It_should_be_plenty_it_is_a_51-volt_5.9_amp_3000_rpm_servo_will_be_plenty_just_wondering_what_Nm's_are..
Its_also_listed_as_kg.m².10-5_on_output..
Oh_and_ebay#120222052667_has_a_picture....
Thanks
GaryV