Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Dickbca on February 19, 2008, 11:09:59 AM
-
Hi Everyone, I just loaded Mach3 v 2.6. Everything looks good except I am unable to change the jog step distance. Also I don't see the picture shown on page 3-6 and page 6-4. The manual I downloaded is version Rev Beta 7.57-A2 and I'm wondering if this is the correct one for the CNC machining program. My thanks in advance. Regards, R. Butterick.
-
Hit your tab key to open the MPG. There you will find lots of settings for mode, step distance, speed %s.
Brett