Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Garyv on February 16, 2008, 10:49:27 PM
-
I have a mill running Mach3 now and I am going to building a router now as well and want to use the same drives and controllers, Is there a way to
save settings for different 2 machines in Mach3?
So all I have to do is unplug motors and limits from one to the other without changing setups or anything?
Thanks
GaryV
-
Not sure if I found it but do I set up a new profile when I start Mach3 under the Mach3 loader icon when I start Mach ?
GaryV
-
That's the way to do it.
Graham.