Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: beezerlm on February 11, 2008, 10:29:13 PM
-
Hello,
Trying to Jog with cnc4pc mpg-2 hooked up to lpt2. It moves all axis but I cannot adjust the increment it moves per click of the mpg. x1 x10 x100 are all the same amount no matter what I do. Seems like I am stuck in velocity mode or something.
Any Ideas? ???
-
Jog increment does not work with all jog modes. Make sure you have configured those job modes under general configuration screen.
Arturo Duncan
http://cnc4pc.com
-
Arturo,
I have configured the x1 x10 and x100 as shown is lpt2 Mpg-2 setup manual under general configuration screen.
X1 is .0001
X10 is .0010
X100 is .0100
-
Try using different jog modes. Go the the diagnostics screen and confirm that the inputs are changing as you turn the selector.
Arturo Duncan
http://cnc4pc.com
-
All jog modes give me the same result. I look at the function of the brain and I can see it switching from x1 to x10 to x100. It does not jog any different though.
-
Do you see in the MPG window? when you press tab? do you see it changing?
Arturo Duncan
http://cnc4pc.com
-
I see mpg window, I flip through the different jog modes, but x1 x10 and x100 do not change anything?
-
;D success!
I shut my system down, double checked all connections, booted back up and single step/multistep worked with the mpg. Not quite sure what the problem was. I was stuck in velocity mode for some reason. Thanks for the Help! :D
-
Glad to hear all is well.
Thanks,
Arturo Duncan
http://cnc4pc.com