Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: SmoothOperator on February 11, 2008, 02:07:35 PM

Title: LazyCam To Mach3:No Display
Post by: SmoothOperator on February 11, 2008, 02:07:35 PM

Many times, when I upload a part program into LazyCam and then output it to Mach3, the G-Code text is there but the part display doesn't appear. My table is set proper as evidenced by previous output parts being displayed and jobs being run successfully. But, other parts don't seem to show up in the disply screen.

What can I do?(or, what am I doing wrong?)

Thanx for helping me become a
"SmoothOperator"

Title: Re: LazyCam To Mach3:No Display
Post by: Chip on February 11, 2008, 02:38:31 PM

Hi, SmoothOperator

Dose the G-code stop on a line prior to finishing loading, theres a white line in the G-code window, The bad G-code is there.

Mach should show the type of error in the Staus: window below.

LCam isn't perfect, Still Bata-ver, Post your G-code and DXF if you like.

Hope this Helps, Chip