Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: BluePinnacle on February 11, 2008, 10:07:32 AM

Title: Writing macros, OEM inputs and outputs
Post by: BluePinnacle on February 11, 2008, 10:07:32 AM

Hello all

Is there a good tutorial or other thread on here which can give me a good overview of writing macros?

Also, how can I configure the OEM inputs and outputs (including renaming them if possible). I've looked though the manual but can't find either ... might just have missed it, do refer me back to the right page if that is the case.

Thanks :)

Title: Re: Writing macros, OEM inputs and outputs
Post by: Overloaded on February 11, 2008, 11:44:11 AM

The best that I could find is Under "Tutorials"
                                              "Documentation"
RC