Machsupport Forum
Support => Forum suggestions and report forum problems. => Topic started by: jeep534 on February 11, 2008, 07:29:52 AM
-
When I look here http://www.artsoftcontrols.com/artsoft/testim/shaun.htm the photo's will not display only the placeholders
Thanks
archie =) =) =)
-
Thanks for the alert. The whole site is about to undergo a full fine tooth combing.
These pics were lost in one of our server moves.
I have a feeling the new site will be really good.
-
Thank you Benny
It would figure that I had not seen those pages before and when i stumbled apon them they were unavailable. what shaun has done is very close to where I want to be in the near future. I have a bridgeport boss, R2E4 Rigid ram, 30 taper, servo machine the bridgeport control is pretty much dead. I have gotten it to home and jog a couple of times but otherwise it is non functional. the control is set up so that it is not possible to interface the PC with the existing hardware requiring a full electronics gut and replace unlike the earlier stepper machines that Hillbilly sells a breakout board and instructions for.
I am going to the mach conference in knoxville this weekend searching for some guidance / inspiration
anyway thanks again for the info
Happy Hunting
archie =) =) =)