Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gorf23 on February 09, 2008, 03:52:49 PM

Title: newfangled 4 axis question
Post by: gorf23 on February 09, 2008, 03:52:49 PM
I tried the 4th axis wizard but it didn't seen to write code out to use the 4th axis, i tried to make a gear and the only movement i got was the z and x but no a...
Am i doing somthing wrong or will the wizard not code for the a axis?...

Thanks gary
Title: Re: newfangled 4 axis question
Post by: Hood on February 09, 2008, 04:00:33 PM
You might get more resonses if you ask  in the new fangled section of this forum. I can move it there if you wish or you can repost yourself or you can just leave it here and maybe you will get an answer.
Hood