Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: james elder on February 01, 2008, 08:24:29 AM
-
Hi guys.
Sorry it's in Mach 2 and I promise to upgrade fast, but can I just get 2 running again?
-Hard disc crash. Backup failed to install this time, but license ok and .xml ok, so all is up and running on new disc ,from a different copy of Mach 2, motors running sweet, x and y responding correctly.. but previously on my 'manual' screen I had an x and y 'trackball' and a z 'trackball' control. Now It's just the x and y.
I guess there's a file I need to copy over, but I can't see which one.
Who can remember that far back?
Thanks in advance
Jim
-
No you fool, It's your screen sets under 'view'.
Jim