Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: wildgrav on January 30, 2008, 06:59:32 PM

Title: BUG unkown
Post by: wildgrav on January 30, 2008, 06:59:32 PM

Education appreciated!!

I created a shape (rough centre board for boat) in Rhino and used Rhinocam to create a tool path to rough it out. The post processor was MACH2. Not sure if that works with MACH3 but I thought it would just be GCODE and be OK. I have attached the TXT file and the screen shot.

Noel

Title: Re: BUG unkown
Post by: Chaoticone on January 30, 2008, 07:11:43 PM

I'm guessing here, but here goes. G43 is apply tool length offset. If you are going to have your code do this I think you will need a H in front of the value and I doubt 0 is a valid value.

Brett

Title: Re: BUG unkown
Post by: wildgrav on January 30, 2008, 07:14:12 PM

Steve Blackmore confirms that.

Thankyou

Noel

Title: Re: BUG unkown
Post by: Chaoticone on January 30, 2008, 07:20:38 PM

Your welcome Noel.

Brett