Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sooperdrave on January 30, 2008, 09:12:42 AM
-
hi, my z axis has stopped working. i had to use the e-stop then i pressed reset and went to ref all home but my z axis was not working. i have tried moving it with commands and manually also i tried powering down and restarting my system, nothing is working. anyone know what i have to do?
thanks sooperdrave
-
Do you have your soft limits enabled?
Brett
-
yes
dave
-
Try disabeling them and ref all home.
Brett