Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: giordano on April 27, 2006, 08:29:36 AM

Title: Discontinuous execution of the contours
Post by: giordano on April 27, 2006, 08:29:36 AM

Hi to all. Since I had any losses of step, I have reduced the acceleration of the 10-20s motors mm s/s. As in the figure.
In this way the execution of a circle is not uniform anymore, but to hiccup. There is a cure. Thanks in advance, Giordano

Title: Re: Discontinuous execution of the contours
Post by: Brian Barker on April 28, 2006, 08:18:54 AM

You have to Retune your axis after you change your Khz mode. Sorry