Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: M250cnc on January 25, 2008, 04:13:28 AM
-
Hi i would like a write wizard please. I have been using the free one but i want more control over the positioning of the text. Mainly i want to be able to set the ref point to be in the centre of the text similar to centre justification.
I would buy the New Fangel for this feature alone. ;D
Thanks
Phil
-
Ive thought about a text engraving wizard, but its a lot harder to do than you might think. It might be more likely if I ever get around to re-writing the wizards in Flash, but so far I have not had much success learning flash.