Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: labuda on January 23, 2008, 10:54:50 PM

Title: Spontaneous Mach Turn Shut off
Post by: labuda on January 23, 2008, 10:54:50 PM

Hi, i used Mach turn for a whole project and things worked ok.
Now, i output a G-code file from mastercam X, ran it in Mach turn, and the thing shut off. I turned the computer on/off and it did it again.
Basically, after loading the file, Mach turn either shuts off right away, or moments later when i start setting up my job. What's going on?
Has anyone experimienced this?

Title: Re: Spontaneous Mach Turn Shut off
Post by: Hood on January 24, 2008, 10:30:24 AM

Do you get any Windows error messages or does Mach just shut down? Can you attach your code so we can see if anything in there is potentially a problem.
Hood