Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wil trower on January 23, 2008, 12:43:23 PM
-
Well I think I have fried my Drive Board and, it is a Stepmaster NC 3 axis Sop-1 Board. Does anyone have there phone number, there web site has (305 671 3860) but it is no longer in service. My thinking is it might be best to replace with the same kind of board since I know very little about this procedure. Any help out there. Thanks Wil
-
If their phone is not working then it might be good idea to buy a similar board in case some thing happens latter you can get a new one faster. Like the one here:
http://cgi.ebay.com/3-AXIS-CNC-Stepper-Stepping-Motor-Driver-Board-kcam4_W0QQitemZ290198979337QQihZ019QQcategoryZ71394QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
-
Thanks Dennis for the info, I will check and see if they are close. The best for me at this stage is a board I can transfer wires from one hole to the next, with the least confusion. Sounds dumb but I am not an electronics guru.