Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: looker1 on April 26, 2006, 06:59:50 PM
-
I am trying to set up and old MaxNC10 board ( it is from the year 1999, not one of the 1018A/B boards mentioned in a help documant I read) with Mach3.
I haven't got backlash compensation to work yet, just delays/pauses in code excecution.
I have read some posts about Mach3 not compensating for backlash in wave mode.
Can someone confirm this?
Is there any mods to the board that can be done?
Thanks
-
Hi:
Its true, in MaxNC modes, there is no software Backlash comp.
It cannot be added at this time..
Only a switchover to new drivers can fix that up..
Sorry,
Art
-
what do I look for in a driver that is compatible?
-
Hi:
I meant motor drivers, not a program driver. It needs to be step/direction before it can backlash correct..
Art