Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: tivoi on January 19, 2008, 05:28:37 AM
-
how to automatic control spindle speed with this motor? any try it?
(http://www.kaizenbonsai.com/shop/images/pt1036_makita.jpg)
-
I take it your idea is to hold this in the Z axis and use it for drilling or something similar
Makita is good equipment - BUT - can you control the speed of the tool as it is.
I do NOT mean by pulling a trigger. Is there any system attached to the tool to control the speed.
The enquiry on your other post gave a brief idea of turning it on and off, but speed control is something different.
Mach 3 can control stepper motors without any problem.
Mach 3 can also put out a PulseWaveModulated signal to control Digispeed and similar motor driver boards.
You might be better served finding a motor on which you can control the speed easily, and then fitting a chuck or similar on it, rather than trying to control a hand tool.
-
Thanks jimpinder
i have one ideas
this is oginal speed control of makita tools
(http://www.electronics-project-design.com/images/LightDimmerSchematic.GIF)
I'' replace varesistor by LDR
(http://img.alibaba.com/photo/11285760/Cds_Photoconductive_Cell_Photoresistor_LDR.jpg)
Then using PWM spindle speed genorator analog and control white led >> LDR >> motor speed
is it possible?
thanks you agian