Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gskinner on January 12, 2008, 08:20:41 PM

Title: Not ignoring tool change
Post by: gskinner on January 12, 2008, 08:20:41 PM
After upgrading to version 3.00 when I get to this line N40t1m06 Mach waits for me to press cycle start again before continuing.  I have ignore tool change selected in configuration.  This is the same file that I ran in the previous version without this problem.  Any ideas what is causing this?

Thanks
George
Title: Re: Not ignoring tool change
Post by: Overloaded on January 12, 2008, 09:32:12 PM
Hey George,
Hood helped me with a similar problem some time back.
We set mine like below and it cycled right through.
Try it in air first.
RC